THESE DIMMERS WILL NOT DIM LEDs.
Z0IP1000-P. 1 or 2 Way 100-1000 Watt Inteligent Dimmer Module Only. Included with the module is an insulating card when attatching module to a metal plate, a nut and also wiring instructions. For Dimmer Knobs please look in our Spare Parts>Knobs Category.
Varilight V-Plus Series Dimmer Module, 1 or 2 Way 1000 Watt Push on/Push off.
VARILIGHT Dimmer Switch Modules have an industry-wide reputation for exceptional performance, long life and innovation at attractive prices. Like all Varilight products these V-Plus Intelligent Series modules are designed to meet the latest European Safety Legislation.
It is important to select the correct dimmer switch module for your application so please read the following information carefully.
The lights are dimmed by a rotary control knob and turned on and off by a push on/off action. V-Plus Intelligent Push on/off dimmer modules are suitable for 1-way and 2-way circuits.
Our V-Plus Intelligent Series Standard Dimmer modules are designed for all incandescent lighting circuits (including mains or low voltage halogen). Use only on an electricity supply of 200-250 volts AC. When using this dimmerswitch to control low voltage lighting transformers, choose transformers with a maximum rating close to the rating of the bulbs they supply (eg. Use a 60VA transformer to control a 50W low voltage bulb). Load at 75% of the maximum load specified on the product label adding the VA ratings of the transformers, not the wattages of the bulbs. Do not overload the transformers. Note: Certain transformers may not behave according to their power rating when used with a dimmer. An overload will always result in the safety features of this dimmerswitch turning down the brightness. If this happens and you have followed these instructions then it is likely that your transformers present a bigger load. In this case, change your transformers to ones which do not appear as an overload, remove one (or some) transformer(s) from the circuit or choose a higher rated dimmer instead. Your best choose Varilight Transformers!
The V-Plus Intelligent Series dimmer modules can be used in 2-way circuits (where one lighting circuit is controlled from two locations). In order to achieve 2-way switching, they must be paired with a standard 2-way switch in the other location. 3-way switching can be achieved by adding an intermediate switch in to the circuit. When using V-Dim Standard Push on/off Dimmer modules in a 2 or 3-way circuit the lights can only be dimmed from the location that the dimmer module is situated in.
The V-Plus Intelligent Series Push on/off Dimmer modules can be used for mains incandescent GLS lamps (standard mains light bulbs), up to the maximum load as specified on the dimmer. They can also dim GU10 or similar Hi Spot Mains Halogen lamps (only use quality UK supplied lamps) up to the maximum load as specified on dimmer, but if greater than 500 Watts, you must downrate them by 75% for this dimmer to work.
Choose V-Pro Dimmer Series if dimming LED's, NOT the V-Plus Series.
The V-Plus Intelligent Push on/ off Dimmer Series are NOT suitable for use with wire wound Transformers or Fans and other inductive loads. Please check with manufacturer of appliance to be dimmed.
This dimmer module has a maximum of 1000 Watts and a minimum of only 100 Watts.
Please see Varilight's recommendation of maximum loads in the Compatibility guide PDF found in "Specs & PDF's"
-Max Load 1000 Watt
-Min Load 100 Watt
-Fits in a 25mm Deep Wall Box, depending on the plate this module is attatched to.
-Generic Dimmer Instructions 552 PDF
-Compatibility 2013 PDF