PLEASE ALLOW 2-3 DAYS FOR THIS PRODUCT TO BE DESPATCHED.
European VariGrid 1 Gang, 1 or 2 Way 400 Watt for GLS Bulbs or 100 Watts for LEDs, with a max of 10 LEDs, V-Pro Series Trailing and Leading Edge Push on/Push off Dimmer with Polished Brass Knob, for use with VariGrid Dimension Screwless Brushed Brass Single, Double and Triple Faceplates, which is part of Varilight's versatile metal grid range for Europe. This insert would take up a 1 hole cut out on the face plate. Eliminate Dimmer Buzz For GLS Bulbs, GU10 LED Lamps, and LV Transformers (for LEDs) Including Trailing Edge LoadsMore Info
VARILIGHT Dimmer Switches have an industry-wide reputation for exceptional performance, long life and innovation at attractive prices.
The V-Pro Series Dimmer can NOT be used for wire-wound Low Voltage transformers, Fans or inductive loads or Halogen lamps
These V-Pro dimmers are Trailing Edge by default, but this can be adjusted to Leading Edge, as shown in the instructions.
These Dimmers can be used in 2-way circuits (where one lighting circuit is controlled from two locations). In order to achieve 2-way switching, they must be paired with a standard 2-way switch in the other location. 3-way switching can also be achieved by adding an intermediate switch in to the circuit. Please note, if total dimming is preferred from all switched locations, in a 2 or 3-way circuit then choose the Varilight Touch and Remote Series range V-Pro IR dimmers, in conjunction with Slave Dimmers.
This Dimmer has a maximum of 400 Watts per dimming module (100 Watts for LEDs) and a minimum of 2 Watts
The V-Pro dimmers are set to a certain level of brightness when first wired up and switched on, the dimmer brightness can now be changed if the LEDs are too bright at the lowest dimmer level, again please see the instructions for details.
These dimmers do not work with lighting panels (LED or CFL). Choose the V-Com range if you are dimming more than 10 LEDs or dimming LED panels.
Please note that only good quality dimmable LEDs should be used. If this dimmer is purchased and the LED lamps are not compatible, the dimmer is not faulty so can not be returned, but a better quality LED lamp/bulb should be fitted instead. As a rule, buy the V-Pro dimmers and LEDs from us to make sure all is compatible.
We only sell products that have the latest software updates, our PDF instruction manuals refer to the product that is being sold. Technical Specifications
-Max Load 400 Watt (100W if using LEDs)
-Min Load 2 Watt
-Fits in a 30mm Deep European square or round Wall Box
-Barcode (EAN): 5021575950588
- Trailing and Leading Edge Dimmer, refer to instructions provided with the dimmer, to allow switching between the modes.
-The Best Dimmer For Most Good Quality Dimmable LED's.
-If dimming more than 10 LEDs, choose the V-Com range.
-This product can be easily cleaned with a soft dry micro-fibre cloth. Never apply masking tape or other similar tape to the product. Avoid the use of any cleaning chemicals and always use a Gasket on freshly plastered, painted or damp walls as the plates may tarnish. (Plaster can take up to 6 months to dry out). If these Instructions are not followed it will void the product warranty.
Product Instructions & Data Sheets
-V-Pro Push Dimmer Instructions 761 PDF
-Screwless Fitting PDF
-Compatibility 2013 PDF
-VariGrid VGEN1 PDF
Z1EGJP1B-P Data Sheet